REMOVE THE ANNOYING BEEP FROM THE FM92
Thanks to Aaron Rigg For this mod
- Remove the covers so the bottom (solder) side of the of the Sythesizer board can be seen.
This is the board under the plastic sheet.
- Postion the unit With one side towards you such that the front panel is on the left and the
rear pannel on the right.
- Locate the dual 11 pin solder rows on the left corner nearest yourself, this is labeled SK403.
- Looking at the row which is further from the front panel, locate the solder point which
is in the middle (6th pin from either end).
- Cut the track joining to this pin with a sharp blade.
- No more BEEP!
USE THIS INFO AT YOUR OWN RISK
I WILL NOT BE HELD RESPONSIBLE FOR ANY
DAMAGE YOU DO TO YOUR
EQUIPMENT